Chrome Antique Vintage Replica 28" 18" -4" Under Stock Springer Fork Front End

BRAND NEW

PART# 35244

Fits most Harley Davidson models with a 1" Neck Stem, Custom Applications such as bobber or chopper & many other custom frames

**(BE SURE TO CHECK YOUR BIKE OR BUILD TO ENSURE FIT!!)**

  SPECIFICS: 
Fully assembled with in-line top bracket without built in rake (0° rake)

The standard length Springer (20" measured from the bottom of the lower tree to the axle center) is comparable to vintage FL model fork length

1" O.D. steering stem designed for Timken® type bearings

Use our Part 36652 neck cup conversion kit to install Springer on K Model and Sportster 1952/1981

Measures 8 3/4" between the axle rockers (Cast rockers)

Includes 3/4" O.D. axle

Rise mounts are on 4 3/4" centers and threaded 1/2-20

Universal brake rod mount is on the right rear leg for disc brakes (5/8" hole)

This length is considered 18" which is measured from the center of the axle to the bottom of the lower triple tree. 19" if you measure to the bearing. Some call it a 28" Springer which is measuring OVERALL length from the axle to the top of the springs. It is actually closer to 29" overall. 

We consider this a 4" Under FXST Softail stock length. Works best on stock rigid or softail frames using either a 16" or 21" wheel. 

This is the front end size we use on most of our bobbers when we want them to sit low. 

Length: 18'' (Center of axle to bottom of lower tree or 19" to where tree sits against the bearing)

Approximate Total Length: 28"-29"

Neck Stem: 1" 

Inside width of Rockers: Approx: 8-1/4"

Axle Diameter: 3/4" O.D.

*** TECH NOTE: INSTALLATION ON SOME STOCK MODELS LIKE DYNA, TOURING, SPORTSTER, ETC MAY REQUIRE FRAME AND/OR TANK MODIFICATION AS WELL AS REPLACEMENT OF OTHER COMPONENTS.

***TECH NOTE: IF USING AN AFTERMARKET/CUSTOM FRAME WITH EXTERNAL NECK CUPS YOU MAY HAVE TO LATHE OR TRIM THE SPRINGER RETAINING NUT DOWN FOR PROPER FITMENT OF TOP TREE CLAMP AND CROWN NUT