Antique Replica Black Copper 30 20" Stock Length Harley Springer Fork Front End

Designer: Mid-USA

Sold Out
Unit Price
SKU 35247

Email me when this is available

Free delivery to the Lower 48 States
30 Day Returns and Exchanges
Fitmet Questions? Call us at 610-754-8500


PART# 35247

Fits: most Harley Davidson models with 1" stem, custom applications such as bobber or chopper, & many other custom motorcycle frames, etc...

**(be sure to check your bike or build to ensure fit!!)**


Notice our manufacturing of this replica v-twin springer front end comes complete and includes upper and lower brass zerk grease fittings, with copper top tree clamp, copper retaining nut, copper top crown nut, a 3/4" front axle kit which includes: axle, (2) copper acorn style end nuts, wheel spacers that can be cut to required length, & various washers/shims. (please note wheel spacers may not be the correct size for your bike or project)


This length is considered 20" which is measured from the center of axle to bottom of lower tree where tree or 21" if you measure to the bearing. Some call it a 30" springer which is measuring overall length from the axle to the top of the springs. Its actually closer to 31". 

We consider this stock length "stock", however of a flst for example this is stock length. Works best on stock rigid and softail frames using either a 16" or 21" wheel. This is the front end size we use on most of our bobbers.

Replica restoration length on antique harley el fl flh knucklehead panhead shovelhead models was even lower than this unit measuring 18"/28" so this would be considered 2" over compared to a stock knucklehead for example.


Length: 20''  (center of axle to bottom of lower tree or 21" to where tree sits against the bearing)

Approximate total length: 30"-31"

Neck Stem: 1" 

Inside width of rockers: approx. 8-1/4"

Axle Diameter: 3/4" o.d.

*** Tech note: installation on some stock models like dyna, touring, sportster, etc may require frame and/or tank modification as well as replacement of other components.

***Tech note: if using an aftermarket/custom frame with external neck cups you may have to lathe or trim the springer retaining nut down for proper fitment of top tree clamp and crown nut!